CARD 1 - SEQUENCER
CARD 2 - RANDOM
Wire a link between pads PIN1A-PIN1B
CARD 3 - ENVELOPE GENERATOR
Wire 2 links between pads PIN1A-PIN1B and PIN2A-PIN2B
CARD 4 - PULSER
CARD 5 - MODULATOR
CARD 6 - MODULATION OSCILLATOR
Wire a link between pads PIN1A-PIN1B
CARD 7 - COMPLEX OSCILLATOR (PART 1)
CARD 8 - COMPLEX OSCILLATOR (PART 2)
CARD 9 - COMPLEX OSCILLATOR (PART 3)
CARD 10 - PREAMP / LPG 1
PIN1 is a signal and PIN2 is a ground, use a shielded wire and connect to a normalized tinijack (preamp input) on a panel, the normalization pin should be also connected to a ground.
CARD 11 - LPG 2
CARD 12 - OUTPUT
Solder IC2, IC3, IC4 directly to a PCB, do not use an IC-socket - this is required for a better cooling of these amplifiers. There's no need to link pads of PIN1A/PIN1B/PIN1C/PIN2.
MOTHERBOARD & PANEL
ASSEMBLY
CALIBRATION:
Please check assembly & calibration instructions at Dave Brown's page.